12/4/2023 0 Comments Downloading Quick CPU 4.6.0![]() These includes fiddling around with KDE power management settings, with (soon deprecated) powersave binary, with cpufreq utils and direct access to /sys/devices/system/cpu/cpu1/cpufreq/. It takes a minute to cool down to 45C, but the cpu may get fast again only like 10-20 minutes later! What freaks me out is that it doesn’t bring the CPU frequency back to normal(=2.8GHz) when the temperature goes down. I can post the screenshots from the sysmon. is over 70c, it gradually throttles the CPUs down to 800MHz. Whenever my laptop (Dell Latitude E6400) overheats, means cpu temp. Unlike in openSUSE 11.3/KDE 4.6, I cannot change the governor from the KDE power management application.įolks, I’m having a similar problem. ![]() The governor "ondemand" may decide which speed to useĬurrent CPU frequency is 800 MHz (asserted by call to hardware).Ĭpufreq stats: 2.67 GHz:0.00%, 2.67 GHz:0.00%, 2.13 GHz:0.00%, 1.60 GHz:0.00%, 800 MHz:100.00%ĬPUs which need to have their frequency coordinated by software: 1 I have made sure that the BIOS has Speedstep enabled, but annoyingly keep getting this: Perhaps:/etc/init.d # cpufreq-infoĬpufrequtils 008: cpufreq-info (C) Dominik Brodowski 2004-2009ĬPUs which run at the same hardware frequency: 0 1ĬPUs which need to have their frequency coordinated by software: 0Īvailable frequency steps: 2.67 GHz, 2.67 GHz, 2.13 GHz, 1.60 GHz, 800 MHzĪvailable cpufreq governors: conservative, userspace, powersave, ondemand, performanceĬurrent policy: frequency should be within 800 MHz and 800 MHz. I did some investigation, and found that the CPU is stuck at 800 MHz (should scale up to 2.67 GHz). 11.3 ran just fine, but 11.4 had been quite sluggish. I’m running openSUSE 11.4 on a Dell Latitude E6500.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |